Elektral ThruScan Instrukcja Użytkownika Pobierz pdf (Strona 35)

Error 06: Right Centre Zone - High Metal Detection for a prolonged period.

Error 07: Left Bottom Zone - High Metal Detection for a prolonged period.

Error 09: Right Bottom Zone - High Metal Detection for a prolonged period.

Error 11: Left Top Zone - No Detection for a prolonged period.

Error 13: Right Top Zone - No Detection for a prolonged period.

Error 14: Left Centre Zone - No Detection for a prolonged period.

Error 16: Right Centre Zone - No Detection for a prolonged period.

Error 17: Left Bottom Zone - No Detection for a prolonged period.

Error 19: Right Bottom Zone - No Detection for a prolonged period.

(*for s3 only 6 error codes i.e.; 00, 06(right panel), 07(left panel), 16(right panel),

17(left panel), 26 is existing)

NOTE: 1)

ThruScan

also continually monitors itself during normal use. Should any of the

above conditions be detected the fault code will be displayed. If no cause is ascertained

pls. contact to the supplier, service company or factory.

2) WTMD,

ThruScan

may display a failure code(error 19) if not used or screened for a

long time. In such case try and screen your WTMd with an unclean object with metal. If

error message continue pls. contact your service company or supplier. Thus be sure

that detection is performed in all areas

6.5 SENSITIVITY

ThruScan has 246 sensitivity settings available for each security level(channel) providing a high

degree of detection accuracy. Sensitivity is used to calibrate the detector to detect precise quantitiy

of metal for any defined object.

NOTE:

ThruScan

is a highly advanced and reliable security metal detector. However, its

success ultimately depends on the training and diligence of the person who operate it

and the overall security plan of which it is a part.

6.6 MEMORY

An electrically erasable non-volatile memory stores all of the program settings whether power is on

or off. Erasing the information stored in the memory is only possible through some procedures

carried out by the user.

6.7 TRAFFIC COUNTER

A built-in and erasable traffic counter counts transitions through WTMD; Incoming & outgoing

traffic counts are independently displayed on LCD display. This specification may be hidden when

requested (See 4.1.9).

(*pls. note

ThruScan

s3/s6 has only one direction counting!)

6.8 TAMPER PROOF

The acces to control panel is double secured by a mechanical lock. And thus it protects the access

to the system controls. Changes to the ‘set-up’ program MENUs are further protected by a 4-digit

PIN CODE (changeable).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 56 57

Komentarze do niniejszej Instrukcji

Brak uwag

Elektral ThruScan Instrukcja Użytkownika Strona 35

Komentarze do niniejszej Instrukcji